Almost three decades serving all 5 NYC boroughs  Β·  Calls answered 24/7  Β·  Mon–Fri 7am–4pm, Saturday by appointment

Calls answered 24/7  Β·  All 5 NYC boroughs

Serving Manhattan β€” Almost Three Decades in Business

Manhattan's HVAC & Mechanical Contractor

High-rises running water-cooled units and PTACs, and brownstones with no ductwork and nowhere obvious to put it. Manhattan mechanical work is defined as much by what the building allows as by what the equipment needs.

Fully Insured
EPA 608 Certified
Calls Answered 24/7
Written Approval Before Any Work
On the Ground

What We Actually See in Manhattan

Building stock determines equipment, and equipment determines what goes wrong. Here is what we work on in Manhattan.

High-rises: water-cooled units and PTACs

Most Manhattan apartment work falls into two categories. Buildings on a condenser water loop put an individual water-cooled unit in each apartment β€” so when one apartment stops cooling, the fault is usually in that unit, not the building system. The failure that matters most is a refrigerant leak into the condenser water loop itself. It affects the whole building and it is easy to miss unless someone isolates the unit and pressure tests it properly.

The other category is through-wall PTAC. These fail predictably: seized fan motors, blocked condensate, corroded coils, failed capacitors. The real question on replacement is usually whether the sleeve and wall opening are still sound enough to take a new unit.

Brownstones and townhouses

These homes were built for radiators and almost never have ductwork, with no practical path to add it. Ductless multi-zone is usually the answer. The difficult part is line set routing β€” through light shafts, up rear facades, inside closets β€” without tearing up finished interiors. In landmarked blocks, where the condenser can go is often decided before any equipment is selected.

What makes Manhattan jobs different

  • Co-op and condo board approval before work can begin
  • Limited or shared roof space for condensing units
  • Rigging and elevator coordination on larger equipment
  • Restricted work hours in occupied residential buildings
  • Long refrigerant line runs affecting charge and sizing

Electrification, and the rebate money on the table

Manhattan is where the electrification shift is moving fastest, and it is where the replacement math has changed most.

New York is paying to move heating load off gas and onto electric. Heat pump installations qualify for incentives under the NYS Clean Heat program, administered through your utility β€” Con Edison or National Grid depending on your address. The amount depends on the equipment, the system type, and whether you're displacing fossil-fuel heat entirely or partially.

That changes the replacement conversation. If you're facing a boiler or furnace replacement, the electric option may land below the gas equivalent once incentives are applied. And on new construction in New York City, gas is no longer an option at all β€” Local Law 154 already applies to buildings under seven stories, with taller buildings following in 2027.

We're a participating Clean Heat contractor. When we quote a replacement we run both numbers β€” conventional equipment and a heat pump with incentives applied β€” so you can compare them rather than take a recommendation on faith. Incentive levels and eligibility rules change, so we confirm what applies to your building at the time of the quote rather than quoting from a brochure.

What We Do

HVAC & Mechanical Services in Manhattan

Residential, commercial, and light industrial. If it heats, cools, or moves air, we service it.
πŸ”₯

Boiler Service & Repair

Steam and hot water boiler maintenance, emergency repair, and replacement.

Manhattan boiler repair β†’
❄️

AC Repair & Service

Diagnostics, refrigerant service, coil cleaning, and system tune-ups.

Learn more β†’
🌑️

Mini-Split & VRF

Ductless and multi-zone diagnosis, installation, and commissioning.

Learn more β†’
♨️

Heat Pump Installation

Full and partial electrification with NYS Clean Heat incentives applied.

Learn more β†’
🏒

Commercial HVAC

Rooftop units, chillers, and building mechanical systems.

Learn more β†’
🏠

System Replacement

Load-calculated sizing and a written cost analysis before you decide.

When is it time? β†’
How We Work

The Bright Star Difference

  • 1

    Repair Over Replace β€” With the Math

    If we can repair it safely, we will. When the numbers stop supporting the repair, we put the analysis on paper so you can check it rather than take our word for it.

  • 2

    Nothing Done Without Written Approval

    The diagnostic charge is emailed and signed before a technician is dispatched. Findings are photographed and explained on site. Any repair requires a signed estimate first.

  • 3

    Sized by Load Calculation, Not Rule of Thumb

    Equipment picked by square footage is equipment that short-cycles, leaves rooms humid, and fails early. We calculate the load.

  • 4

    The 5-Star Way β€” Every Visit

    Booties on every job, unit wiped down before we leave, work area left clean. Your building is not a job site.

Service Area

Manhattan Neighborhoods We Serve

Upper East Side Upper West Side Midtown Murray Hill Chelsea Greenwich Village SoHo Tribeca Financial District Hell's Kitchen Harlem Morningside Heights Washington Heights Inwood East Village Lower East Side Gramercy Kips Bay Battery Park City Roosevelt Island

Not listed? Call us β€” we very likely cover your block.

πŸ“ž Check My Address

Need a technician in Manhattan?

Tell us what the system is doing. We'll diagnose it, document what we find, and give you the numbers before any work begins.

Scroll to Top
Call (212) 516-9632
Calls answered 24/7 · No-heat calls get priority